Please use this identifier to cite or link to this item:
|Title:||Position-moored drilling vessel in level ice by control of riser end angles|
Riser end angles
|Citation:||Nguyen, D.H., Nguyen, D.T., Quek, S.T., Sørensen, A.J. (2011-05). Position-moored drilling vessel in level ice by control of riser end angles. Cold Regions Science and Technology 66 (2-3) : 65-74. ScholarBank@NUS Repository. https://doi.org/10.1016/j.coldregions.2011.01.007|
|Abstract:||This paper focuses on the control of marine riser of a position-moored drilling vessel operating under level ice regime with different ice thicknesses. The strategy is to ensure that the riser end angles (REAs) are within the safe limits for drilling and work-over operations by keeping the vessel at an appropriate position. Using a control criterion based on REAs, the desired vessel position is computed to counteract the environmental disturbances. An optimal set-point chasing algorithm is used to control the mooring lines by adjusting their lengths to bring the vessel to the desired position. The ice load model of Nguyen et al. (2009) was used to simulate the vessel-ice interaction. Numerical simulation results of a moored drilling vessel first exposed to open water and then to level ice of different thicknesses indicated that the proposed control strategy performs satisfactorily in level ice regime. The riser end angles and bending stresses along the riser are reduced considerably when in automatic control mode. © 2011 Elsevier B.V.|
|Source Title:||Cold Regions Science and Technology|
|Appears in Collections:||Staff Publications|
Show full item record
Files in This Item:
There are no files associated with this item.
checked on Jul 17, 2018
WEB OF SCIENCETM
checked on Jun 20, 2018
checked on Jul 6, 2018
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.