Please use this identifier to cite or link to this item:
|Title:||Process tomographic measurements of granular flow in a pneumatic conveying system|
|Citation:||Yao, J., Lim, E.W.C., Wang, C.-H., Li, N. (2012). Process tomographic measurements of granular flow in a pneumatic conveying system. Advanced Materials Research 508 : 75-79. ScholarBank@NUS Repository.|
|Abstract:||The application of process tomography (PT) technologies, i.e. Electrostatic Tomography (EST) and Electrical Capacitance Tomography (ECT) to investigate complex industrial processes has obtained wide popularity in recent years. This study focuses on the characterization of non-uniformly distributed electrostatic effects across the cross-section of a pneumatic transportpipe. A digital electrometer was used to measure the electrostatics current and an ECT was used to observe the particle distribution in a vertical pipe. Due to non-uniform particle-wall collisions, the electrostatics generated was observed to be non-uniformly distributed across the pipe cross-section, especially at pipe bends and in a vertical pipe. Large electrostatic effects were associated with high particle concentration in the pipe. There was a good correspondence between the electrostatic effects measured and particle concentration distributions obtained using ECT. Based on ECT measurements at the vertical pipe section, it was observed that particles tended to concentrate at sections where generation of electrostatic charges was high. Thus, it is clear that electrostatic effects should be the key factor giving rise to non-uniform particle concentration distribution in pneumatic transport lines. © (2012) Trans Tech Publications.|
|Source Title:||Advanced Materials Research|
|Appears in Collections:||Staff Publications|
Show full item record
Files in This Item:
There are no files associated with this item.
checked on Jun 8, 2018
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.