Please use this identifier to cite or link to this item:
|Title:||Comparison of performance of four RFID sensor antennas fabricated on different substrates|
|Citation:||Tarapata, G., Hui, H.T., Weremczuk, J., Jachowicz, R., Shi, C.W.P., Shan, X. (2009). Comparison of performance of four RFID sensor antennas fabricated on different substrates. APMC 2009 - Asia Pacific Microwave Conference 2009 : 614-617. ScholarBank@NUS Repository. https://doi.org/10.1109/APMC.2009.5384149|
|Abstract:||This paper reports the interface designed for wireless data and power transmission to RFID sensor. The interface hardware was realized on four different substrates: PCB (Printed Circuit Board), LCP (Liquid Crystal Polymer), LTCC (Low Temperature Co-fired Ceramics) and PET (Polyethylene Terephthalate). Different techniques and materials were used to fabricate conductive traces adequately on each substrate. Presented techniques and materials for antenna fabrication were compared and tested in RFID application. Fabricated RFID antennas work at 13.56 MHz and measure 20.7×18.9 mm2 in size and have 4 turns of coil winding. Achieved measurement results show that sensors can be wirelessly powered in distance from 2 to 5 cm depending on used substrate. ©2009 IEEE.|
|Source Title:||APMC 2009 - Asia Pacific Microwave Conference 2009|
|Appears in Collections:||Staff Publications|
Show full item record
Files in This Item:
There are no files associated with this item.
checked on Mar 21, 2019
WEB OF SCIENCETM
checked on Mar 12, 2019
checked on Mar 16, 2019
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.