Please use this identifier to cite or link to this item:
|Title:||An experimental study of slot-jet impingement and mist cooling of microprocessors|
|Authors:||Tay, A.A.O. |
|Source:||Tay, A.A.O.,Ang, S.S.T.,Lwin, L.O. (2006). An experimental study of slot-jet impingement and mist cooling of microprocessors. Thermomechanical Phenomena in Electronic Systems -Proceedings of the Intersociety Conference 2006 : 175-180. ScholarBank@NUS Repository. https://doi.org/10.1109/ITHERM.2006.1645340|
|Abstract:||This paper describes an experimental study of air slot-impingement and mist cooling of microchannels fabricated on the back of a silicon chip. A rig was designed and fabricated for the experimental study. The test section consisted of a 21mm × 21mm square silicon die with 100μm-wide microchannels etched on its back surface, which were covered with a glass plate to confine the flow through the microchannels. A slot was machined across the glass cover plate to admit air from an inlet manifold. The performance of an air-water mist spray cooling system was also studied experimentally. It was found that an air-water mist spray cooling system can give a higher cooling rate than air-only slot-impingement cooling of microchannels. For the same heat dissipation, it was found that the air-water mist spray cooling system required a much smaller flow rate of air. Comparing with data available in the literature, it was also found that mist cooling of microchannels was much more effective than on plane surfaces. © 2006 IEEE.|
|Source Title:||Thermomechanical Phenomena in Electronic Systems -Proceedings of the Intersociety Conference|
|Appears in Collections:||Staff Publications|
Show full item record
Files in This Item:
There are no files associated with this item.
checked on Dec 11, 2017
checked on Dec 9, 2017
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.