Please use this identifier to cite or link to this item: http://scholarbank.nus.edu.sg/handle/10635/58367
Title: Identification of effective zones for high pressure coolant in milling
Authors: Rahman, M. 
Senthil Kumar, A. 
Choudhury, M.R.
Issue Date: 2000
Source: Rahman, M.,Senthil Kumar, A.,Choudhury, M.R. (2000). Identification of effective zones for high pressure coolant in milling. CIRP Annals - Manufacturing Technology 49 (1) : 47-52. ScholarBank@NUS Repository.
Abstract: Effective zones of high pressure coolant have been identified in milling performing a wide range of machining operations on ASSAB 718 mould steel using un-coated tungsten carbide inserts. The effects of high pressure coolant are evaluated in terms of machining parameters by comparing with those of conventional coolant and dry cut. Chipping and catastrophic failure are the dominant factors of insert rejection for dry cut and conventional coolant, whereas progressive flank wear is observed for high pressure coolant within its effective zones at lower depth of cut, lower feed rate and higher cuffing speed. It is found that the cutting force is reduced, surface finish is improved, chip width is narrowed and cooling effect is better with the use of high pressure coolant.
Source Title: CIRP Annals - Manufacturing Technology
URI: http://scholarbank.nus.edu.sg/handle/10635/58367
ISSN: 00078506
Appears in Collections:Staff Publications

Show full item record
Files in This Item:
There are no files associated with this item.

Page view(s)

33
checked on Dec 8, 2017

Google ScholarTM

Check


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.