Effect of several finishing processes on the fatigue resistance of hole surfaces

Abstract

This investigation examines the effects of different finishing processes on the fatigue lie of premachined holes in Assab 760 steel plates. The finishing processes studied were reaming, ballizing, and emery polishing. A general decrease in fatigue life with increase in surface roughness is observed for all the processes employed. In comparing the different processes, for a constant surface roughness, polishing is generally found to give the longest fatigue life while ballizing, in spite of the greater compressive residual stresses induced on the surface of the finished hole, the shortest. The surprising phenomenon was found to be attributed to the amount of plastic deformation occurred before fatigue loading. For Assab 760 steel, a prestrain in the radial direction of less than about 2.5 percent appeared to reduce the fatigue resistance of the material.